Introduction

Face Editor is essentially a series of editing and ‘paving’ on the face. Functionally, it can divide the area, parametric paving, tiling, free paving, and making boundaries and waist lines.

How to go to Face Editor?

There are three ways to do face editor:

  1. Once you click on a wall/floor/ceiling in 3D model, you will see Face Editor in the floating bar.

2. When you go to Advanced Tool - Construction

Click on a wall/floor/ceiling in 3D model, you will see Face Edit in the floating bar.

3.Click on a wall/floor/ceiling in 3D model, you will see Wall Editor/Floor Editor/ Ceiling Editor in the floating bar.Click on it.

Then you will see Face Editor.

These are three different ways, but to do the same edit: Face Editor.

We can modify different faces of the room here.

 Note: To go back to Face Editor from Floor Plan, follow Step Two and Step Three mentioned above.

Did this answer your question?